<![CDATA[SoliForum - 3D Printing Community — Print shifted half inch!]]> https://www.soliforum.com/topic/1962/print-shifted-half-inch/ Wed, 10 Apr 2013 21:19:08 +0000 PunBB <![CDATA[Re: Print shifted half inch!]]> https://www.soliforum.com/post/19322/#p19322 Got it working, it was the voltage on the x,y,z motors.  I adjusted it based on the troubleshooting page on solidoodle's site and now its working fantastic.

solidoodle.[com]/how-to-2/troubleshooting

Thanks all.

]]> Wed, 10 Apr 2013 21:19:08 +0000 https://www.soliforum.com/post/19322/#p19322 <![CDATA[Re: Print shifted half inch!]]> https://www.soliforum.com/post/18751/#p18751 My wire harness was hitting my end stop switch.  Once I printed the wire guide it worked fine.

B

]]> Sat, 06 Apr 2013 02:45:02 +0000 https://www.soliforum.com/post/18751/#p18751 <![CDATA[Re: Print shifted half inch!]]> https://www.soliforum.com/post/18669/#p18669 Check your belt tensions first. That was my solution to the problem.

]]> Fri, 05 Apr 2013 11:04:10 +0000 https://www.soliforum.com/post/18669/#p18669 <![CDATA[Re: Print shifted half inch!]]> https://www.soliforum.com/post/18634/#p18634 Search "shifting", there are many topics on it that will be very helpful

]]> Thu, 04 Apr 2013 21:39:29 +0000 https://www.soliforum.com/post/18634/#p18634 <![CDATA[Print shifted half inch!]]> https://www.soliforum.com/post/18626/#p18626 Hello,

Brand new to this world, working with a solidoodle 3.  So far been pretty successful, but I am having a problem with a print shifting about a half inch, everytime.  I have tried using slicer and Skeinforge and I am getting the same thing, as far as I can see as I jump through the layers in Repetier it does not move.

Attached is an image of what happened.

This is the thing I am trying to print.

thing:30572
RasPi_Case2_Bottom_Vesa.stl

Any ideas why this would happen?  How can I troubleshoot this?

Thanks in advance...

]]> Thu, 04 Apr 2013 21:12:40 +0000 https://www.soliforum.com/post/18626/#p18626