<![CDATA[SoliForum - 3D Printing Community — When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into]]> https://www.soliforum.com/topic/18789/when-printing-from-cura-on-da-vinci-jr-10-pro-the-nozzle-digs-into/ Sun, 20 Dec 2020 20:26:39 +0000 PunBB <![CDATA[Re: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into]]> https://www.soliforum.com/post/154290/#p154290 Jonahdb2 wrote:
Tin Falcon wrote:

sound like z offset needs to change

is there a z offset you recommend? also this does not happen using XYZware

I recommend to check if your printer is level first and then go into the offset settings. As far as number well I would lift it up until its not digging into the printer anymore and then adjust until its barely touching the bed.

]]> Sun, 20 Dec 2020 20:26:39 +0000 https://www.soliforum.com/post/154290/#p154290 <![CDATA[Re: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into]]> https://www.soliforum.com/post/154282/#p154282 Tin Falcon wrote:

sound like z offset needs to change

is there a z offset you recommend? also this does not happen using XYZware

]]> Fri, 18 Dec 2020 23:00:54 +0000 https://www.soliforum.com/post/154282/#p154282 <![CDATA[Re: When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into]]> https://www.soliforum.com/post/154276/#p154276 sound like z offset needs to change

]]> Thu, 17 Dec 2020 10:11:55 +0000 https://www.soliforum.com/post/154276/#p154276 <![CDATA[When printing from cura on Da Vinci jr. 1.0 pro the nozzle digs into]]> https://www.soliforum.com/post/154265/#p154265 the bed tape (this and title says it all)

]]> Tue, 15 Dec 2020 15:36:45 +0000 https://www.soliforum.com/post/154265/#p154265