SoliForum - 3D Printing Community — vertical hopper stl for version 2

Re: vertical hopper stl for version 2

null@example.com (tekstyle) — Sat, 11 Jul 2020 10:35:27 +0000

looks like i had to disassemble. now to mount the hopper after i pick up some screws. thank you

Re: vertical hopper stl for version 2

null@example.com (genesat1) — Tue, 07 Jul 2020 14:35:07 +0000

tekstyle wrote:

Oh ok. That will work! Didn’t think to rotate it 90 degrees to the side. Do I need to disassemble the whole thing or can I just rotate the barrel from the flange at where to 2 joins?

You would need to rotate it into a tighter position which might be quite difficult depending on just how tightened it already is. It would probably be easier to just go ahead and take the 4 bolts off, rotate, and reassemble.

Re: vertical hopper stl for version 2

null@example.com (tekstyle) — Thu, 02 Jul 2020 17:18:06 +0000

Oh ok. That will work! Didn’t think to rotate it 90 degrees to the side. Do I need to disassemble the whole thing or can I just rotate the barrel from the flange at where to 2 joins?

Re: vertical hopper stl for version 2

null@example.com (genesat1) — Thu, 02 Jul 2020 15:38:55 +0000

I use this one: https://www.thingiverse.com/thing:1195942

You may need to rotate the barrel 90 degrees to get the hole to line up since the hopper goes off to the side on v2 with this design.

vertical hopper stl for version 2

null@example.com (tekstyle) — Thu, 02 Jul 2020 07:59:27 +0000

is there a vertical hopper stl for the version 2 of the filastruder? i only found them for the version 1.