<![CDATA[SoliForum - 3D Printing Community — Motor throwing objects off turntable]]> https://www.soliforum.com/topic/18656/motor-throwing-objects-off-turntable/ Fri, 12 Jun 2020 22:43:04 +0000 PunBB <![CDATA[Re: Motor throwing objects off turntable]]> https://www.soliforum.com/post/153545/#p153545 hairu526 wrote:

Vixx,

You should have received a high friction liner for the turntable to prevent objects from slowly moving as the table turns.

Uriah

I did, but it also slips around, Perhaps I should score the PLA table so it has more surface area to grip the liner

]]> Fri, 12 Jun 2020 22:43:04 +0000 https://www.soliforum.com/post/153545/#p153545 <![CDATA[Re: Motor throwing objects off turntable]]> https://www.soliforum.com/post/153538/#p153538 Vixx,

You should have received a high friction liner for the turntable to prevent objects from slowly moving as the table turns.

Uriah

]]> Fri, 12 Jun 2020 11:39:22 +0000 https://www.soliforum.com/post/153538/#p153538 <![CDATA[Re: Motor throwing objects off turntable]]> https://www.soliforum.com/post/153531/#p153531 It should not turn fast enough to throw anything off. It should turn just a fraction, pause for the scan and repeat till done. If the start and stop is too fast you may have to look at the code and check acceleration settings.

]]> Fri, 12 Jun 2020 00:49:59 +0000 https://www.soliforum.com/post/153531/#p153531 <![CDATA[Motor throwing objects off turntable]]> https://www.soliforum.com/post/153529/#p153529 One of the numerous issues I've been having with my Atlas is that about a third to halfway through a scan the objects on the turntable get thrown off of it.  This seems to happen primarily with tall or thin objects.  Is there a setting I can adjust to help with this problem?

]]> Fri, 12 Jun 2020 00:22:41 +0000 https://www.soliforum.com/post/153529/#p153529