SoliForum - 3D Printing Community — Max layer thickness

Re: Max layer thickness

null@example.com (dubbsd) — Tue, 02 Jun 2020 18:09:18 +0000

The ultimaker S3 uses Cura and when I changed from the .4 nozzle to the .8 nozzle in Cura it made all the changes
including slowing from 70mm/s to 35mm/s But it did not change the TEMP. but I have not had any problems.

after some test runs I started printing Biastape makers again for the people in the area making masks. the one i am printing calls for 2 shells .24 layer thickness no infill and it was taking about 1Hr each print. But with the .8 nozzle with the same layer thickness same settings bit only 1 shell I am getting 2 in that hour time frame.

Dale

Re: Max layer thickness

null@example.com (heartless) — Tue, 02 Jun 2020 12:30:23 +0000

funny thing about that general 75% rule.. the larger you go in nozzle diameter, the lower that percentage is going to get.
found this out when I put the volcano on the FT 5 a while back.. a 0.8 nozzle will perform best at more like 0.45-0.5 layer height - and yes, definitely increase temps a fair bit as you are flowing a lot more plastic..

Re: Max layer thickness

null@example.com (dubbsd) — Tue, 02 Jun 2020 02:31:14 +0000

Thanks
doing a test print now.

Re: Max layer thickness

null@example.com (Tin Falcon) — Tue, 02 Jun 2020 00:42:06 +0000

general rule of thumb 75% of nozzle diameter. so a .8 would be 0.6 max layer.

Max layer thickness

null@example.com (dubbsd) — Mon, 01 Jun 2020 23:58:49 +0000

I just got in a .8mm Printcore (nozzle) for my printer
starting off with PLA 200°C and .3 mm layer thickness 35mm/s print speed. I have a couple places where the filament did not bond. so I will raise the temp. But what is the max Good layer thickness I can go with this Nozzle and PLA.

Thanks
Dale