https://www.soliforum.com/topic/18569/filament-bunching-up-between-extruder-gear-and-e3d-v6/ Tue, 05 May 2020 02:58:20 +0000 PunBB https://www.soliforum.com/post/153213/#p153213 It must’ve been a clogged extruder tip, took it off and cleaned it out, now it’s printing fine.  Also ordered more tubing so I can cut it a little longer, closer to the gears.

]]> Tue, 05 May 2020 02:58:20 +0000 https://www.soliforum.com/post/153213/#p153213 https://www.soliforum.com/post/153212/#p153212 It must’ve been a clogged extruder tip, took it off and cleaned it out, now it’s printing fine.  Also ordered more tubing so I can cut it a little longer, closer to the gears.

]]> Tue, 05 May 2020 02:58:12 +0000 https://www.soliforum.com/post/153212/#p153212 https://www.soliforum.com/post/153209/#p153209 Not sure where the design for the mount came from but it is missing an important detail. The inlet of the hotend should be much closer to the gear or there should be a tube from the inlet right up to the gear so there is no space for the filament to move in between the gear and inlet. The there could also be a clog.

]]> Mon, 04 May 2020 20:43:48 +0000 https://www.soliforum.com/post/153209/#p153209 https://www.soliforum.com/post/153208/#p153208 Looks like it could be a hard clog in the nozzle that's backing up the filament. I'd disassemble and clean the hotend.

]]> Mon, 04 May 2020 20:31:20 +0000 https://www.soliforum.com/post/153208/#p153208 https://www.soliforum.com/post/153202/#p153202 This just started happening a few days ago after it has been printing pretty much flawlessly about 12 hrs a day, everyday for the past 3 weeks.  Any ideas as to what could keep causing this to happen?  This one is about 2 hours into a 2.5 hour print:

]]> Mon, 04 May 2020 17:52:22 +0000 https://www.soliforum.com/post/153202/#p153202