SoliForum - 3D Printing Community — Please, help me. My Da Vinci 1.0A is making this horrors

Re: Please, help me. My Da Vinci 1.0A is making this horrors

null@example.com (Tin Falcon) — Tue, 07 Apr 2020 10:47:34 +0000

you can not think you need to check

I was making some protection masks for doctors and nurses (those masks ran out in Spain) . I'd print a lot of them and I hadn't any problems. But suddenly they started go wrong.

check mechanical first then electronic I doubt it is a software issue if the thing printed fine then things went belly up.

Re: Please, help me. My Da Vinci 1.0A is making this horrors

null@example.com (dosveces) — Tue, 07 Apr 2020 10:37:40 +0000

I think they're right.

Re: Please, help me. My Da Vinci 1.0A is making this horrors

null@example.com (Tin Falcon) — Tue, 07 Apr 2020 10:32:28 +0000

check your belts & pulleys looks like something slipping

Please, help me. My Da Vinci 1.0A is making this horrors

null@example.com (dosveces) — Tue, 07 Apr 2020 10:02:58 +0000

I was making some protection masks for doctors and nurses (those masks ran out in Spain) . I'd print a lot of them and I hadn't any problems. But suddenly they started go wrong.

I've changed the nozzle by a new one. But it doesn't get better.

Can you help me ?

It's a problem with the electric feed of the resistor heater of the nozzle?

It's a problem with the gear of the x-axe?

It's a problem with the servomotor (engine) of the x-axe?

It's a problem with the stl file? The samples inside the printer goes right.

Please, help me.