https://www.soliforum.com/topic/1845/test-print/ Mon, 25 Mar 2013 03:35:28 +0000 PunBB https://www.soliforum.com/post/17614/#p17614 ah ah no lol I'll have to do that ,  thanks for the tip. I must have wasted just as much.

]]> Mon, 25 Mar 2013 03:35:28 +0000 https://www.soliforum.com/post/17614/#p17614 https://www.soliforum.com/post/17611/#p17611 Are you sure you calibrated your extrusion settings correctly?  I went through 3/4 roll of filament before I broke down and calibrated it.  I'd double check those and heat it up a little.

]]> Mon, 25 Mar 2013 02:50:14 +0000 https://www.soliforum.com/post/17611/#p17611 https://www.soliforum.com/post/17605/#p17605 ok thanks, I'll try that

]]> Mon, 25 Mar 2013 00:10:26 +0000 https://www.soliforum.com/post/17605/#p17605 https://www.soliforum.com/post/17604/#p17604 This is where the new layers start, you probably need to turn up the retraction amount in slic3r a bit and also turning off randomize start points would make it easier to clean up.

]]> Sun, 24 Mar 2013 23:53:46 +0000 https://www.soliforum.com/post/17604/#p17604 https://www.soliforum.com/post/17603/#p17603 Please take a look at the two pictures.This is just a simple .3mm cube print.As you can see 3 sides print perfectly but the fourth
does not.Any ideas?

]]> Sun, 24 Mar 2013 23:36:00 +0000 https://www.soliforum.com/post/17603/#p17603