<![CDATA[SoliForum - 3D Printing Community — doubt printing with minimover]]> https://www.soliforum.com/topic/18449/doubt-printing-with-minimover/ Thu, 27 Feb 2020 09:38:57 +0000 PunBB <![CDATA[Re: doubt printing with minimover]]> https://www.soliforum.com/post/152672/#p152672 Yes, that is what I do, it is in case the meters did not always go down to use minimover, but seen the seen I use the official software that prints me better than cure (for not having to configure so much)
thanks!

]]> Thu, 27 Feb 2020 09:38:57 +0000 https://www.soliforum.com/post/152672/#p152672 <![CDATA[Re: doubt printing with minimover]]> https://www.soliforum.com/post/152668/#p152668 ebsigma wrote:

I have an emutag, if I print with minimover a file generated with a cure, is it subtracting me meters of filament in the tag?

Yes it does then you just reset the tag before it reaches zero or the printer flags it as empty.

]]> Wed, 26 Feb 2020 22:06:44 +0000 https://www.soliforum.com/post/152668/#p152668 <![CDATA[doubt printing with minimover]]> https://www.soliforum.com/post/152666/#p152666 I have an emutag, if I print with minimover a file generated with a cure, is it subtracting me meters of filament in the tag?

]]> Wed, 26 Feb 2020 21:08:25 +0000 https://www.soliforum.com/post/152666/#p152666