<![CDATA[SoliForum - 3D Printing Community — Question]]> https://www.soliforum.com/topic/18355/question/ Sun, 29 Dec 2019 21:14:22 +0000 PunBB <![CDATA[Re: Question]]> https://www.soliforum.com/post/152278/#p152278 danijelfurjan3 wrote:

i have a stl of that but the writer is still running at 210, not changing the temperature ..


You have to have software that allows you to program temp changes at various levels. The software your machine runs on does not allow this nor can you change the temps unless you change the controller to something like a Ramps 1.4. On your machine the fialment chip sets the temp and it is controlled by the color.

]]> Sun, 29 Dec 2019 21:14:22 +0000 https://www.soliforum.com/post/152278/#p152278 <![CDATA[Re: Question]]> https://www.soliforum.com/post/152275/#p152275 i have a stl of that but the writer is still running at 210, not changing the temperature ..

]]> Sun, 29 Dec 2019 15:07:48 +0000 https://www.soliforum.com/post/152275/#p152275 <![CDATA[Re: Question]]> https://www.soliforum.com/post/152267/#p152267 You need the stl of that then put it into your slicer/host program and have the slicer send it to the printer.

]]> Sat, 28 Dec 2019 18:35:07 +0000 https://www.soliforum.com/post/152267/#p152267 <![CDATA[Question]]> https://www.soliforum.com/post/152266/#p152266 http://soliforum.com/i/?ev1pf5Z.jpg



through which program to inject this so I can test the temperature

]]> Sat, 28 Dec 2019 10:05:19 +0000 https://www.soliforum.com/post/152266/#p152266