<![CDATA[SoliForum - 3D Printing Community — New build - No power to the motor]]> https://www.soliforum.com/topic/18306/new-build-no-power-to-the-motor/ Sat, 30 Nov 2019 23:01:38 +0000 PunBB <![CDATA[Re: New build - No power to the motor]]> https://www.soliforum.com/post/152034/#p152034 Really confused here.

Where are you measuring this voltage difference?

Are you certain you have not reversed polarity to the stall protection board? If you do, it will act like a direct short, and trip the power supply's overload protection.

A Filastruder power supply is rated for 100-240v, at least if purchased in the last several months, maybe longer. Not sure why you bought a different supply, but if it is rated for 3 amps output, it is not enough. The heater alone draws 3 amps.

]]> Sat, 30 Nov 2019 23:01:38 +0000 https://www.soliforum.com/post/152034/#p152034 <![CDATA[Re: New build - No power to the motor]]> https://www.soliforum.com/post/151993/#p151993 I've disassembled everything and put it back together and still the same problem.

The only change I've made is that I ordered a new adapter off ebay to suit Australian voltages... is it possible the new adapter isn't powerful enough? It's says 3A on the label, but it's from china so you never know.

...Should I just suck it up and buy a 5A adapter from a retailer, then try again?

]]> Wed, 27 Nov 2019 11:03:01 +0000 https://www.soliforum.com/post/151993/#p151993 <![CDATA[Re: New build - No power to the motor]]> https://www.soliforum.com/post/151991/#p151991 Sounds like you need to go back through your wiring and check everything out

]]> Wed, 27 Nov 2019 10:47:29 +0000 https://www.soliforum.com/post/151991/#p151991 <![CDATA[New build - No power to the motor]]> https://www.soliforum.com/post/151990/#p151990 Hi all,

I have just built the Filastruder and i'm not recieving any power to the motor.

The PID turns on, and I can measure a voltage difference of 12V when not heating (0.6V when heating), however when I turn the motor switch on, the PID turns off and the voltage difference is 0.6V.

The stall protection LCD does not turn on at all. I have tried to adjust CC/CV however that also does nothing. The fans also do not turn on. Just the PID and the heater seem to work.

Does anyone have any ideas on what I can do?

]]> Wed, 27 Nov 2019 06:54:08 +0000 https://www.soliforum.com/post/151990/#p151990