<![CDATA[SoliForum - 3D Printing Community — CR10-S gaps in print/all layers]]> https://www.soliforum.com/topic/18276/cr10s-gaps-in-printall-layers/ Sun, 24 Nov 2019 15:47:14 +0000 PunBB <![CDATA[Re: CR10-S gaps in print/all layers]]> https://www.soliforum.com/post/151952/#p151952 228 is probably a bit low temp wise, especially on an E3D... I run 235-240 on my E3Ds for most ABS filaments.
Bed temp is also a bit low.. 90-110C is typical

Have you updated the firmware with the correct thermistor profile for the E3D? it should be set to table 5 for accurate temp readings.

Have you properly calibrated your E steps? If you ask it to feed 100mms in, does it feed EXACTLY 100mms?

]]> Sun, 24 Nov 2019 15:47:14 +0000 https://www.soliforum.com/post/151952/#p151952 <![CDATA[Re: CR10-S gaps in print/all layers]]> https://www.soliforum.com/post/151943/#p151943 Enclosure had already been installed.

]]> Sun, 24 Nov 2019 00:38:35 +0000 https://www.soliforum.com/post/151943/#p151943 <![CDATA[Re: CR10-S gaps in print/all layers]]> https://www.soliforum.com/post/151816/#p151816 markkcunningham wrote:

Printer:CR10-S/full enclosure
E3D head
S3D slicer/SD card
Filament: Gizmo 1.75mm ABS/.04 nozzle
Temp: 228/80
I think this picture says it all!

Make sure the machine is properly calibrated first. I see blobs which indicate overextrusion. You also cant use ABS well without an enclosed printer or printer in enclosure. Ambient temp must be warm and stable around print.

]]> Wed, 13 Nov 2019 11:22:32 +0000 https://www.soliforum.com/post/151816/#p151816 <![CDATA[CR10-S gaps in print/all layers]]> https://www.soliforum.com/post/151815/#p151815 Printer:CR10-S/full enclosure
E3D head
S3D slicer/SD card
Filament: Gizmo 1.75mm ABS/.04 nozzle
Temp: 228/80
I think this picture says it all!

]]> Wed, 13 Nov 2019 03:07:26 +0000 https://www.soliforum.com/post/151815/#p151815