<![CDATA[SoliForum - 3D Printing Community — Prints only print rough on the right side of the printer]]> https://www.soliforum.com/topic/18265/prints-only-print-rough-on-the-right-side-of-the-printer/ Fri, 01 Nov 2019 09:55:25 +0000 PunBB <![CDATA[Re: Prints only print rough on the right side of the printer]]> https://www.soliforum.com/post/151756/#p151756 Is it bowden fed? When it gets to the rough side the tube could be making the filament hang up

]]> Fri, 01 Nov 2019 09:55:25 +0000 https://www.soliforum.com/post/151756/#p151756 <![CDATA[Re: Prints only print rough on the right side of the printer]]> https://www.soliforum.com/post/151755/#p151755 Do you have a layer fan and does it blow from only one side?

]]> Thu, 31 Oct 2019 22:15:07 +0000 https://www.soliforum.com/post/151755/#p151755 <![CDATA[Re: Prints only print rough on the right side of the printer]]> https://www.soliforum.com/post/151754/#p151754 i would suggest that 220 is too hot... try 200
also make sure the spool is turning freely, not hanging up at all

]]> Thu, 31 Oct 2019 21:57:04 +0000 https://www.soliforum.com/post/151754/#p151754 <![CDATA[Prints only print rough on the right side of the printer]]> https://www.soliforum.com/post/151753/#p151753 Printer: Monoprice Select v2
Filament: Overture White PLA
Printing Temp: 220º C

I just switched to this filament (cheap from Amazon) and it prints fine until it gets to the right side of the object (see attached pics).  I am at a loss for a setting to address this.  I am going to do a temperature test print as well as an overall quality check but I have not run into this before where a specific area of each print is being affected.

http://soliforum.com/i/?4K4qRMN.jpg
http://soliforum.com/i/?vXSgEwj.jpg

]]> Thu, 31 Oct 2019 04:58:57 +0000 https://www.soliforum.com/post/151753/#p151753