<![CDATA[SoliForum - 3D Printing Community — filament pushes up]]> https://www.soliforum.com/topic/18071/filament-pushes-up/ Sun, 27 Oct 2019 21:57:08 +0000 PunBB <![CDATA[Re: filament pushes up]]> https://www.soliforum.com/post/151741/#p151741 My printer has the same problem! what did you do to fix (if anything)? post it here please http://www.soliforum.com/post/151740

]]> Sun, 27 Oct 2019 21:57:08 +0000 https://www.soliforum.com/post/151741/#p151741 <![CDATA[Re: filament pushes up]]> https://www.soliforum.com/post/150410/#p150410 Thnx for the answers!
I’m going to try the scotchtape, thnx for that tip.

@carl...Can’t i just print some new compression fittings?

]]> Sun, 12 May 2019 20:17:19 +0000 https://www.soliforum.com/post/150410/#p150410 <![CDATA[Re: filament pushes up]]> https://www.soliforum.com/post/150409/#p150409 You can also just measure and buy new compression fittings. They are a common plumbing part.

]]> Sun, 12 May 2019 19:13:28 +0000 https://www.soliforum.com/post/150409/#p150409 <![CDATA[Re: filament pushes up]]> https://www.soliforum.com/post/150408/#p150408 I have a different type printer but the Filament guide tube Kept coming out of the Extruded so I wrapped a layer of Scotch tape around the tube end.

]]> Sun, 12 May 2019 18:29:07 +0000 https://www.soliforum.com/post/150408/#p150408 <![CDATA[filament pushes up]]> https://www.soliforum.com/post/150405/#p150405 Hi guys,

On my davinci junior 1.0 the filament pushes out of the guide tube..

The print starts good but after a while the guide tube comes out of that metal insert.
It happens once that the guide tube comes out on the side of the filament roll, and once it came out on the side of the printhead..

Anyone knows this issue?

Thnx,

Greettzzz,

Micha.

]]> Sun, 12 May 2019 12:16:07 +0000 https://www.soliforum.com/post/150405/#p150405