SoliForum - 3D Printing Community — Semplify 3d question

Re: Semplify 3d question

null@example.com (dubbsd) — Sun, 14 Apr 2019 16:27:05 +0000

Heartless
Keep your grammar check to yourself!!

Dale

Re: Semplify 3d question

null@example.com (heartless) — Sun, 14 Apr 2019 16:08:52 +0000

and it is sImplify3D not semplify.

Re: Semplify 3d question

null@example.com (wardjr) — Sun, 14 Apr 2019 14:52:54 +0000

Depends on the print but I typically prefer prime pillar. I usually set my pillar 10mm square far out in a corner. This works well if your non print travel speeds are at least 80mm/sec.

Semplify 3d question

null@example.com (dubbsd) — Sun, 14 Apr 2019 14:16:48 +0000

which is best to use prime pillar or ooze shield.
I am printing PETG with a dual extruder.

Thanks
Dale