<![CDATA[SoliForum - 3D Printing Community — fan on stepper motor speeds up and slows down]]> https://www.soliforum.com/topic/18013/fan-on-stepper-motor-speeds-up-and-slows-down/ Sun, 31 Mar 2019 21:30:30 +0000 PunBB <![CDATA[Re: fan on stepper motor speeds up and slows down]]> https://www.soliforum.com/post/149982/#p149982 I swapped back over to the right extruder and it is printing good so I guess both fans went at the same time.
will install new fan on left extruder.
Thanks
Dale

]]> Sun, 31 Mar 2019 21:30:30 +0000 https://www.soliforum.com/post/149982/#p149982 <![CDATA[Re: fan on stepper motor speeds up and slows down]]> https://www.soliforum.com/post/149981/#p149981 dubbsd wrote:

I am running semplify 3d.
the fan on the stepper motor speeds up than almost stops.

I was printing with the right extruder the other day and It started doing it so I changed out the fan.
Today I tried to print with the left extruder and it is doing the same thing.could the other fan be going out also or
do I have a board problem.

Thanks
Dale


Without replacing the fans with a known good 24 volt fan you have no way of knowing if the issue is the fans or the driver for them.

]]> Sun, 31 Mar 2019 21:17:54 +0000 https://www.soliforum.com/post/149981/#p149981 <![CDATA[fan on stepper motor speeds up and slows down]]> https://www.soliforum.com/post/149980/#p149980 I am running semplify 3d.
the fan on the stepper motor speeds up than almost stops.

I was printing with the right extruder the other day and It started doing it so I changed out the fan.
Today I tried to print with the left extruder and it is doing the same thing.could the other fan be going out also or
do I have a board problem.

Thanks
Dale

]]> Sun, 31 Mar 2019 20:57:30 +0000 https://www.soliforum.com/post/149980/#p149980