<![CDATA[SoliForum - 3D Printing Community — Help, I broke two wires and don't know where they went]]> https://www.soliforum.com/topic/17933/help-i-broke-two-wires-and-dont-know-where-they-went/ Tue, 12 Feb 2019 01:36:01 +0000 PunBB <![CDATA[Re: Help, I broke two wires and don't know where they went]]> https://www.soliforum.com/post/149040/#p149040 A couple option that i believe will work


https://folgertech.com/products/high-st … -hot-end-1


https://www.amazon.com/dp/B07JGJKPT9/re … 5168c9e43c

]]> Tue, 12 Feb 2019 01:36:01 +0000 https://www.soliforum.com/post/149040/#p149040 <![CDATA[Re: Help, I broke two wires and don't know where they went]]> https://www.soliforum.com/post/149039/#p149039 Looks like it's the therositer.  Where do I find a replacement for the solidoodle 2?

]]> Tue, 12 Feb 2019 00:48:52 +0000 https://www.soliforum.com/post/149039/#p149039 <![CDATA[Re: Help, I broke two wires and don't know where they went]]> https://www.soliforum.com/post/149038/#p149038 Ah I think it'sfor temp.  Would it go where this red dot is?

]]> Mon, 11 Feb 2019 23:19:06 +0000 https://www.soliforum.com/post/149038/#p149038 <![CDATA[Re: Help, I broke two wires and don't know where they went]]> https://www.soliforum.com/post/149029/#p149029 If you aren't getting a temperature reading from the hotend, like it says -1 or something not logical, then it was the thermistor. If you are reading ambient temps and the temps don't change then they go to the heating element.

As for the filament getting stuck, it looks like you have loads of dust in extruder. I gather this thing sat in someone's basement or shed for a while before you got it from them. You will want to get some canned air or your air compressor out and blast that sucker good before you use it. That dust will cause you all kinds of heartache as it will easily clog up the hotend.

The repair should be pretty easy for either of those parts. You just need to take the extruder apart to get the hotend out so you can find out what part to replace.

]]> Mon, 11 Feb 2019 16:46:33 +0000 https://www.soliforum.com/post/149029/#p149029 <![CDATA[Help, I broke two wires and don't know where they went]]> https://www.soliforum.com/post/149024/#p149024 I had a piece of filamient get stuck in the feeder and in an attempt to get it free two wires seen in picture were knocked out. I purchased this used so, so these two wires looked like they had been fixed before. I can't tell if they go together or go somewhere. The extruder and the bed wont heat, but everything else seems to turn on.

]]> Mon, 11 Feb 2019 14:35:58 +0000 https://www.soliforum.com/post/149024/#p149024