<![CDATA[SoliForum - 3D Printing Community — Sang 1.3a help]]> https://www.soliforum.com/topic/17826/sang-13a-help/ Tue, 01 Jan 2019 00:04:26 +0000 PunBB <![CDATA[Re: Sang 1.3a help]]> https://www.soliforum.com/post/148236/#p148236 hammade90 wrote:
heartless wrote:

do you have your Arduino set up properly?
Correct board selected?
Correct processor selected?
Correct COM port selected?

everything was working the other day.

That does not mean something didn't somehow get changed - check it all to verify.

also, main power "should" be shut down, for flashing you should only need USB power to the board
and no other programs connected to the printer (close RH, or whatever you use)

]]> Tue, 01 Jan 2019 00:04:26 +0000 https://www.soliforum.com/post/148236/#p148236 <![CDATA[Re: Sang 1.3a help]]> https://www.soliforum.com/post/148223/#p148223 make sure no other apps (repetier host or whatever you use to control the printer) connected to printer. Disconnect or close other apps before attempt upload.

]]> Mon, 31 Dec 2018 19:04:53 +0000 https://www.soliforum.com/post/148223/#p148223 <![CDATA[Re: Sang 1.3a help]]> https://www.soliforum.com/post/148216/#p148216 heartless wrote:

do you have your Arduino set up properly?
Correct board selected?
Correct processor selected?
Correct COM port selected?

everything was working the other day.

]]> Mon, 31 Dec 2018 13:41:01 +0000 https://www.soliforum.com/post/148216/#p148216 <![CDATA[Re: Sang 1.3a help]]> https://www.soliforum.com/post/148214/#p148214 do you have your Arduino set up properly?
Correct board selected?
Correct processor selected?
Correct COM port selected?

]]> Mon, 31 Dec 2018 13:10:24 +0000 https://www.soliforum.com/post/148214/#p148214 <![CDATA[Sang 1.3a help]]> https://www.soliforum.com/post/148207/#p148207 Binary sketch size: 54588 bytes (of a 63488 byte maximum)
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

]]> Mon, 31 Dec 2018 05:02:32 +0000 https://www.soliforum.com/post/148207/#p148207