<![CDATA[SoliForum - 3D Printing Community — Led light to each homing switch]]> https://www.soliforum.com/topic/1766/led-light-to-each-homing-switch/ Tue, 19 Mar 2013 02:05:55 +0000 PunBB <![CDATA[Re: Led light to each homing switch]]> https://www.soliforum.com/post/16915/#p16915 Nice to know they were hit and also set the z stop to where the table is currently at.

]]> Tue, 19 Mar 2013 02:05:55 +0000 https://www.soliforum.com/post/16915/#p16915 <![CDATA[Re: Led light to each homing switch]]> https://www.soliforum.com/post/16905/#p16905 Look here:

http://reprap.org/mediawiki/images/f/f5 … u_1.3a.png

There's three wires on an endstop:
+ 5/12v
signal
GND

Wire an LED between signal and GND with an appropriate sized resistor for 5 or 12 volts that your jumper is set to.

]]> Tue, 19 Mar 2013 00:17:43 +0000 https://www.soliforum.com/post/16905/#p16905 <![CDATA[Re: Led light to each homing switch]]> https://www.soliforum.com/post/16904/#p16904 I don't,  but curious as to why?

]]> Tue, 19 Mar 2013 00:06:08 +0000 https://www.soliforum.com/post/16904/#p16904 <![CDATA[Led light to each homing switch]]> https://www.soliforum.com/post/16899/#p16899 Anyone know how to wire a led light to each homing switch.

]]> Mon, 18 Mar 2013 23:06:26 +0000 https://www.soliforum.com/post/16899/#p16899