Comes out around 9"/22mm height, making it about 1/9th scale.  Planning to sand it down & paint.

Edit: Uploaded to thingiverse
https://www.thingiverse.com/thing:3078651

Most of the odd bits are from XYZ getting confused about my bad 3d modeling.  Still, came out in one piece (I snapped off a wing on purpose to get into the supports.

But I'm working on a more... friendly way of printing it:

Gotta re-do the right arm (the one with the gattling gun) because no matter what the sliced result is fubar.  Gonna try a 0.1mm layer height with the bits.

I am betting this is going to give you all kinds of problems and require major support. But good luck. You are far braver than I. I doubt even my SLA could pull that off without a lot of support.

Just a little support:

Lol

Older versions of the default DaVinci program seem to work pretty well when it comes to slicing and supports, and since I make my own NTAG filament chips I'm a bit more adventurous with PLA.

Thank god for a good reference picture

It is more or less a rigged 3d model: apparently the default pose in the pic makes it back heavy.
Waiting to see how the print turns out -15cm tall @ 16 hours printing- before I upload the pose to thingiverse.