<![CDATA[SoliForum - 3D Printing Community — filawinder question]]> https://www.soliforum.com/topic/17470/filawinder-question/ Mon, 16 Jul 2018 12:56:55 +0000 PunBB <![CDATA[Re: filawinder question]]> https://www.soliforum.com/post/145157/#p145157 A little bit of tape works great

]]> Mon, 16 Jul 2018 12:56:55 +0000 https://www.soliforum.com/post/145157/#p145157 <![CDATA[Re: filawinder question]]> https://www.soliforum.com/post/145152/#p145152 was thinking about hot glue it in the hole.
don't think I want a laser dropping out smile

thanks for the reply

]]> Mon, 16 Jul 2018 09:54:00 +0000 https://www.soliforum.com/post/145152/#p145152 <![CDATA[Re: filawinder question]]> https://www.soliforum.com/post/145145/#p145145 You could put a few wraps of tape around the laser to increase its diameter.

]]> Sun, 15 Jul 2018 15:38:17 +0000 https://www.soliforum.com/post/145145/#p145145 <![CDATA[filawinder question]]> https://www.soliforum.com/post/145143/#p145143 Hi, purchased the filastruder and filawinder.

Haven't started to build the filastruder yet. just working on the filawinder.

I've noticed the STL's don't match the parts I received.
Motor gear doesn't fit. the arm for bolt, the plate holes for screws don't line up to lazer cut part.

Biggest problem so far, is the Lazer. Docs says use flat screw driver open lazer cut pieces and release
when you put the lazer into hole. But the lazer WAY smaller than hole. It just drops out.
How should I hold it in place?

]]> Sun, 15 Jul 2018 08:09:14 +0000 https://www.soliforum.com/post/145143/#p145143