<![CDATA[SoliForum - 3D Printing Community — The chassis mounted bushings]]> https://www.soliforum.com/topic/1733/the-chassis-mounted-bushings/ Fri, 15 Mar 2013 16:05:17 +0000 PunBB <![CDATA[Re: The chassis mounted bushings]]> https://www.soliforum.com/post/16623/#p16623 IanJohnson wrote:

The holes are 1/2" so if you are going to a 1/4" rod, you could look for a 1/2" OD 1/4" ID flanged ball bearing and get smoother motion, maybe reduce backlash.  McMaster has one - 57155K323

My idea here is to first upgrade my Y axis to MXL pulley with the FairLoc(TM) hubs.  To confirm that it works as I expect.  Then to upgrade all the belts on that Y axis to urethane/Kevlar and see how that works out.  Then change out the belt and gear pulleys between the Y stepper and the shaft above it to a GT2 belt which should reduce the backlash about 1/2.  For that I'll use a bore reducer(s) as most of the GT2 belts and gears are Gates Power Transmission parts and on inch measurements for the bore.

If all else fails then everything is going to GT2 belts.  I can always put the existing gear pulleys into something else.
If GT2 belts don't reduce the backlash on this then there's no sense in messing with that anymore.

If everything is GT2 belts it only makes sense to use 1/4" shafts on everything and toss the bore reducers.

]]> Fri, 15 Mar 2013 16:05:17 +0000 https://www.soliforum.com/post/16623/#p16623 <![CDATA[Re: The chassis mounted bushings]]> https://www.soliforum.com/post/16618/#p16618 The holes are 1/2" so if you are going to a 1/4" rod, you could look for a 1/2" OD 1/4" ID flanged ball bearing and get smoother motion, maybe reduce backlash.  McMaster has one - 57155K323

]]> Fri, 15 Mar 2013 15:51:37 +0000 https://www.soliforum.com/post/16618/#p16618 <![CDATA[Re: The chassis mounted bushings]]> https://www.soliforum.com/post/16616/#p16616 They would never tell any of us that.  They won't even say what size the screws are for the door hinges.

]]> Fri, 15 Mar 2013 15:46:20 +0000 https://www.soliforum.com/post/16616/#p16616 <![CDATA[The chassis mounted bushings]]> https://www.soliforum.com/post/16609/#p16609 I am thinking about changing out the Y axis shaft above the Y axis stepper for a 0.25" shaft instead of a 6mm shaft.
Does anyone know where they got those bushings and mounts for them or was this something fabricated?

If I can't get this information then I'll just use bore reducers.

]]> Fri, 15 Mar 2013 15:21:47 +0000 https://www.soliforum.com/post/16609/#p16609