<![CDATA[SoliForum - 3D Printing Community — SD3 Noob: 0.1 mm Flow calibration question]]> https://www.soliforum.com/topic/1699/sd3-noob-01-mm-flow-calibration-question/ Wed, 13 Mar 2013 06:55:51 +0000 PunBB <![CDATA[Re: SD3 Noob: 0.1 mm Flow calibration question]]> https://www.soliforum.com/post/16250/#p16250 I adjusted the extruder using R/H EEPROM parameter and then the flow by printing the box, measuring the wall and adjusting the multiplier.

]]> Wed, 13 Mar 2013 06:55:51 +0000 https://www.soliforum.com/post/16250/#p16250 <![CDATA[Re: SD3 Noob: 0.1 mm Flow calibration question]]> https://www.soliforum.com/post/16240/#p16240 It looks to me like your bed height is a bit to high and material is squishing out. Also, your skirt isn't even showing. How did you adjust the flow? If you did it in firmware then no, you won't have to change anything anymore. Its tough to get good prints on .1 without a fan. I recently added the extruder fan and I wonder why I waited so long.

]]> Wed, 13 Mar 2013 04:17:58 +0000 https://www.soliforum.com/post/16240/#p16240 <![CDATA[SD3 Noob: 0.1 mm Flow calibration question]]> https://www.soliforum.com/post/16238/#p16238 Hello,

After many hours of tweaking, I was able to get close to a descent 0.3mm prints.  At 0.1mm it seems like there is an excess filament being extruded.

Do I need to perform the same flow rate calibration I did for 0.3mm but for 0.1mm?

Thank you in advance for your help,

CB

]]> Wed, 13 Mar 2013 03:16:56 +0000 https://www.soliforum.com/post/16238/#p16238