<![CDATA[SoliForum - 3D Printing Community — Extrusion problems]]> https://www.soliforum.com/topic/16589/extrusion-problems/ Sun, 16 Jul 2017 04:00:31 +0000 PunBB <![CDATA[Re: Extrusion problems]]> https://www.soliforum.com/post/136662/#p136662 mjf55 wrote:

Mr Clown, that is a great solution.  Do you find that the adjustment bolt loosens over time form the vibration?  The single wing nut hold it well?



The wing nut seems to hold it just fine.

]]> Sun, 16 Jul 2017 04:00:31 +0000 https://www.soliforum.com/post/136662/#p136662 <![CDATA[Re: Extrusion problems]]> https://www.soliforum.com/post/136661/#p136661 Mr Clown, that is a great solution.  Do you find that the adjustment bolt loosens over time form the vibration?  The single wing nut hold it well?

]]> Sun, 16 Jul 2017 02:10:49 +0000 https://www.soliforum.com/post/136661/#p136661 <![CDATA[Re: Extrusion problems]]> https://www.soliforum.com/post/136658/#p136658 thanks guys this seems to have fixed the issue

]]> Sat, 15 Jul 2017 18:51:14 +0000 https://www.soliforum.com/post/136658/#p136658 <![CDATA[Re: Extrusion problems]]> https://www.soliforum.com/post/136657/#p136657 Kitt_Beesley wrote:

So my Davinci Jr. is only printing on half of the table. I followed the cleaning instructions and cleared a blockage yet it still only prints on the side closest to the filament spool. on the far half of the table it only leaves a heat impression on the table but no filament. and the driver clicks repeatedly how do I fix this?


Tin Falcon was 100%. Here is how I took care of that problem on my JR. There should already be a threaded hole o n the right side of the extruder support bar. I believe it is 4 or 5mm, check to make sure. Use the paper trick to adjust the Z axis. See attached for complete fix.


http://soliforum.com/i/?dfJxBMF.jpg

]]> Sat, 15 Jul 2017 17:11:18 +0000 https://www.soliforum.com/post/136657/#p136657 <![CDATA[Re: Extrusion problems]]> https://www.soliforum.com/post/136654/#p136654 sounds like you need to level the table.

]]> Sat, 15 Jul 2017 16:45:11 +0000 https://www.soliforum.com/post/136654/#p136654 <![CDATA[Extrusion problems]]> https://www.soliforum.com/post/136653/#p136653 So my Davinci Jr. is only printing on half of the table. I followed the cleaning instructions and cleared a blockage yet it still only prints on the side closest to the filament spool. on the far half of the table it only leaves a heat impression on the table but no filament. and the driver clicks repeatedly how do I fix this?

]]> Sat, 15 Jul 2017 15:46:39 +0000 https://www.soliforum.com/post/136653/#p136653