SoliForum - 3D Printing Community — No pillars on my overhangs!

Re: No pillars on my overhangs!

null@example.com (diyengineer) — Tue, 17 Jul 2018 23:25:13 +0000

Buy yourself a $10 raspberry pi zero and run octoprint. Cura has been working really well for me. Soliprint is trash.

Re: No pillars on my overhangs!

null@example.com (knowack) — Wed, 04 Jul 2018 02:26:41 +0000

I bounce back and forth between Slic3r and Cura; I find that occasionally where one has problems slicing, the other will do a better job.

Re: No pillars on my overhangs!

null@example.com (carl_m1968) — Tue, 03 Jul 2018 23:30:25 +0000

jessvuso wrote:

Hi guys, my 1st post here.. having a nightmare with the slic3r settings on my solidoodle press....
I'm using soliprint and trying to print something that has a 45 degree angle (see pic below), but nothing I do will get the support pillars to generate!(slic3r settings are also below.)
Does anyone have a clue for me? Many thanks in advance

http://manual.slic3r.org/expert-mode/support-material

Re: No pillars on my overhangs!

null@example.com (diyengineer) — Tue, 03 Jul 2018 23:15:59 +0000

Use CURA! I really liked Slic3r until i figured out Cura. I think Slic3r is still a good program, but honestly give it a shot.

No pillars on my overhangs!

null@example.com (jessvuso) — Sun, 04 Jun 2017 11:53:22 +0000

Hi guys, my 1st post here.. having a nightmare with the slic3r settings on my solidoodle press....

I'm using soliprint and trying to print something that has a 45 degree angle (see pic below), but nothing I do will get the support pillars to generate!(slic3r settings are also below.)

Does anyone have a clue for me? Many thanks in advance