<![CDATA[SoliForum - 3D Printing Community — Brand new davinci 1.0 pro stepper hitting the side]]> https://www.soliforum.com/topic/16479/brand-new-davinci-10-pro-stepper-hitting-the-side/ Wed, 31 May 2017 21:18:40 +0000 PunBB <![CDATA[Re: Brand new davinci 1.0 pro stepper hitting the side]]> https://www.soliforum.com/post/135778/#p135778 Problem solved, removed the rear panel and the x and z axis stepper connectors were loose, when re-seated all was well.

]]> Wed, 31 May 2017 21:18:40 +0000 https://www.soliforum.com/post/135778/#p135778 <![CDATA[Re: Brand new davinci 1.0 pro stepper hitting the side]]> https://www.soliforum.com/post/135757/#p135757 Good idea I'll get him to give it a try or check the output with a meter.

]]> Tue, 30 May 2017 21:28:30 +0000 https://www.soliforum.com/post/135757/#p135757 <![CDATA[Re: Brand new davinci 1.0 pro stepper hitting the side]]> https://www.soliforum.com/post/135756/#p135756 The endstop it's self could be bad. just swap it for another and see if the problem follows the endstop. Did he buy it new or used? If used is the firmware stock?

]]> Tue, 30 May 2017 21:09:32 +0000 https://www.soliforum.com/post/135756/#p135756 <![CDATA[Brand new davinci 1.0 pro stepper hitting the side]]> https://www.soliforum.com/post/135755/#p135755 I have a friend who has just bought a new 1.0 pro and whenever he tries to calibrate, the x axis, I think, just hits the side and the stepper bangs.
He's check the end stop wiring and it looks good.

Anybody seen this before?

]]> Tue, 30 May 2017 21:08:03 +0000 https://www.soliforum.com/post/135755/#p135755