<![CDATA[SoliForum - 3D Printing Community — E3D V6 on a CTC Dual]]> https://www.soliforum.com/topic/16386/e3d-v6-on-a-ctc-dual/ Wed, 26 Apr 2017 01:52:38 +0000 PunBB <![CDATA[Re: E3D V6 on a CTC Dual]]> https://www.soliforum.com/post/134941/#p134941 Tell us what you need and we will be able to get you the correct combination.
https://support.printitindustries.com/

]]> Wed, 26 Apr 2017 01:52:38 +0000 https://www.soliforum.com/post/134941/#p134941 <![CDATA[E3D V6 on a CTC Dual]]> https://www.soliforum.com/post/134903/#p134903 I am looking to convert my CTC from the MK10 extruders and hot ends it has to E3D V6 with Bowden. Those who may not know the CTC is a 24V system and uses thermocouples instead of thermistors.

So I see there are 24 volt version of the E3D and if I order two of them can I get them with thermocouples instead of thermistors? I can chnage the inputs on the Azteeg X5 I have controlling it but it means changing pin mapping in the firmware and that is just a pain and I am not sure what the original pins for thermistors where so additional research would need to be done. Aside from the carriage and some tweaking I was just hoping for a near drop in.

]]> Tue, 25 Apr 2017 15:52:47 +0000 https://www.soliforum.com/post/134903/#p134903