SoliForum - 3D Printing Community — What's the issue with sticking ???

Re: What's the issue with sticking ???

null@example.com (wire10ga) — Tue, 05 Mar 2013 18:02:25 +0000

I went to glass/hairspray so that I could keep the bed hot and get setup for another print without using a pry bar.

Re: What's the issue with sticking ???

null@example.com (cckens) — Tue, 05 Mar 2013 16:41:42 +0000

De-lamination is just part of the fun

Actually I had no issues with sticking on the original bed with the kapton, but I did have de-lamination of the edges, but that's a bed issue. I switched to glass-hairspray and re-calibrated. Still have the de-lamination on some of my larger prints, but it's gotten better.

Re: What's the issue with sticking ???

null@example.com (paeltz) — Tue, 05 Mar 2013 14:27:47 +0000

I haven't had any sticking problems after I got everything calibrated. Before calibration I had all sorts of issues. I also switched to glass so I can switch beds easier. I don't have to wait for the bed to cool down to remove the part only to heat back up again.

What's the issue with sticking ???

null@example.com (Harvey) — Tue, 05 Mar 2013 13:38:17 +0000

Hi, not posted for some time, but still having a great time designing and printing stuff.

I was just reading the forum and it's impressive all the posts about using hairspray and other stuff to make the ABS stick to the krapton bed..... but what' the issue ? I just leave mine heat to 95° and it sticks fine (big parts, small parts, ...) ? Also, just leave it cool down to unstick (to avoid damaging the krapton)... So what's all the fuss about?