<![CDATA[SoliForum - 3D Printing Community — What is this?]]> https://www.soliforum.com/topic/15919/what-is-this/ Mon, 13 Feb 2017 08:17:35 +0000 PunBB <![CDATA[Re: What is this?]]> https://www.soliforum.com/post/132456/#p132456 i have used teflon tape on mine, if you dont have access to Kapton, just wrap it three times around. As well, I couldn't get it to fit into the control box so I took it apart and carefully noted which was pos and neg. Then it was simple to put the wires under the screws.

]]> Mon, 13 Feb 2017 08:17:35 +0000 https://www.soliforum.com/post/132456/#p132456 <![CDATA[Re: What is this?]]> https://www.soliforum.com/post/130708/#p130708 Kapton tape would be the best.

]]> Sat, 07 Jan 2017 22:29:54 +0000 https://www.soliforum.com/post/130708/#p130708 <![CDATA[Re: What is this?]]> https://www.soliforum.com/post/130699/#p130699 how to attach the probe to the hole in the nozzle?

]]> Sat, 07 Jan 2017 20:34:53 +0000 https://www.soliforum.com/post/130699/#p130699 <![CDATA[Re: What is this?]]> https://www.soliforum.com/post/129806/#p129806 No problem. I'm planning to spend some time updating the instructions soon, will keep this in mind.

]]> Mon, 26 Dec 2016 16:32:10 +0000 https://www.soliforum.com/post/129806/#p129806 <![CDATA[Re: What is this?]]> https://www.soliforum.com/post/129805/#p129805 elmoret wrote:

Object in photo is thermocouple. It is mentioned in the instructions, yellow plug goes to PID controller, probe goes to hole in the side of the nozzle.

Thank you so much! I was very confused and now I understand. Once again thank yoy!

]]> Mon, 26 Dec 2016 16:29:15 +0000 https://www.soliforum.com/post/129805/#p129805 <![CDATA[Re: What is this?]]> https://www.soliforum.com/post/129804/#p129804 Object in photo is thermocouple. It is mentioned in the instructions, yellow plug goes to PID controller, probe goes to hole in the side of the nozzle.

]]> Mon, 26 Dec 2016 16:22:54 +0000 https://www.soliforum.com/post/129804/#p129804 <![CDATA[What is this?]]> https://www.soliforum.com/post/129803/#p129803 http://soliforum.com/i/?DBWpAdM.jpg
What is that on the electrical diagram is it the t-couple or the heater? Also where does it go? The PDF for the filastruder makes no reference as to where it goes. It seems to have a hot and a ground polarity but the heater band that goes near the nozzle seems to have no polarity leaving me to think that the object in the picture is the t-couple. Any ideas?

]]> Mon, 26 Dec 2016 16:18:53 +0000 https://www.soliforum.com/post/129803/#p129803