<![CDATA[SoliForum - 3D Printing Community — Da Vainci Jr. Bed adhesion method?]]> https://www.soliforum.com/topic/15905/da-vainci-jr-bed-adhesion-method/ Fri, 23 Dec 2016 23:54:55 +0000 PunBB <![CDATA[Re: Da Vainci Jr. Bed adhesion method?]]> https://www.soliforum.com/post/129679/#p129679 carl_m1968 wrote:
totalitarian wrote:
carl_m1968 wrote:

Use Elmers purple glue stick. It works much better on cold beds.

Do you apply it straight to the glass?


yes and just wait fro the purple to go away. If you do have trouble removing the object just soak it and the glass in water.

Great I'll give it a go thanks

]]> Fri, 23 Dec 2016 23:54:55 +0000 https://www.soliforum.com/post/129679/#p129679 <![CDATA[Re: Da Vainci Jr. Bed adhesion method?]]> https://www.soliforum.com/post/129678/#p129678 totalitarian wrote:
carl_m1968 wrote:
totalitarian wrote:

Just tried printing on the tape that came with my Jr. and the print stuck a little too well. I had to remove the glass and use a chisel to get the print off.

Anyone else have better success?


Use Elmers purple glue stick. It works much better on cold beds.

Do you apply it straight to the glass?


yes and just wait fro the purple to go away. If you do have trouble removing the object just soak it and the glass in water.

]]> Fri, 23 Dec 2016 23:50:53 +0000 https://www.soliforum.com/post/129678/#p129678 <![CDATA[Re: Da Vainci Jr. Bed adhesion method?]]> https://www.soliforum.com/post/129675/#p129675 carl_m1968 wrote:
totalitarian wrote:

Just tried printing on the tape that came with my Jr. and the print stuck a little too well. I had to remove the glass and use a chisel to get the print off.

Anyone else have better success?


Use Elmers purple glue stick. It works much better on cold beds.

Do you apply it straight to the glass?

]]> Fri, 23 Dec 2016 23:09:37 +0000 https://www.soliforum.com/post/129675/#p129675 <![CDATA[Re: Da Vainci Jr. Bed adhesion method?]]> https://www.soliforum.com/post/129673/#p129673 totalitarian wrote:

Just tried printing on the tape that came with my Jr. and the print stuck a little too well. I had to remove the glass and use a chisel to get the print off.

Anyone else have better success?


Use Elmers purple glue stick. It works much better on cold beds.

]]> Fri, 23 Dec 2016 23:04:51 +0000 https://www.soliforum.com/post/129673/#p129673 <![CDATA[Da Vainci Jr. Bed adhesion method?]]> https://www.soliforum.com/post/129653/#p129653 Just tried printing on the tape that came with my Jr. and the print stuck a little too well. I had to remove the glass and use a chisel to get the print off.

Anyone else have better success?

]]> Fri, 23 Dec 2016 19:20:49 +0000 https://www.soliforum.com/post/129653/#p129653