<![CDATA[SoliForum - 3D Printing Community — Help X axis stops]]> https://www.soliforum.com/topic/15879/help-x-axis-stops/ Wed, 21 Dec 2016 11:01:54 +0000 PunBB <![CDATA[Re: Help X axis stops]]> https://www.soliforum.com/post/129517/#p129517 Checked all the wiring and it seams ok (anyway i will be making new wiring becouse its an upgraded version, larger, and i want to make the conection in one piece with no weldin betwen)
I have earlier checked the power on the chip, now i have changed to a A4988 and testing.
so managed to print 3 pieces (suports for the gt2560 board with cooling) and it seams ok

]]> Wed, 21 Dec 2016 11:01:54 +0000 https://www.soliforum.com/post/129517/#p129517 <![CDATA[Re: Help X axis stops]]> https://www.soliforum.com/post/129448/#p129448 Check x axis wiring

]]> Tue, 20 Dec 2016 11:20:55 +0000 https://www.soliforum.com/post/129448/#p129448 <![CDATA[Help X axis stops]]> https://www.soliforum.com/post/129447/#p129447 I have the following setup

Board : GT2560 (also tryed with ramps, but the same)

Drivers:

DRV8825 for x, y, and z axis

A4988 for the extruder

Firmware Marlin and repetier

Everything is working fine until i star printing, after a few layers (usualy 3 or 4 layers) the x axis just stops, and even if i reset the board wont move.

The only way it gets working agains is if i unplug everything and start over.

Checked voltage on the drivers and endstops and it seams ok just before starting to print.

Can someone give me a hand please?

]]> Tue, 20 Dec 2016 10:44:22 +0000 https://www.soliforum.com/post/129447/#p129447