<![CDATA[SoliForum - 3D Printing Community — Davinci jr print head digging into protective tape]]> https://www.soliforum.com/topic/15867/davinci-jr-print-head-digging-into-protective-tape/ Mon, 19 Dec 2016 19:33:25 +0000 PunBB <![CDATA[Re: Davinci jr print head digging into protective tape]]> https://www.soliforum.com/post/129425/#p129425 This video shows how to adjust your Z offset, which I'm fairly sure is the problem with your printer.

]]> Mon, 19 Dec 2016 19:33:25 +0000 https://www.soliforum.com/post/129425/#p129425 <![CDATA[Re: Davinci jr print head digging into protective tape]]> https://www.soliforum.com/post/129325/#p129325 Did a factory reset but nothing changed, the z offset setting says .3mm

Z axis reads .1mm

]]> Sat, 17 Dec 2016 22:16:35 +0000 https://www.soliforum.com/post/129325/#p129325 <![CDATA[Re: Davinci jr print head digging into protective tape]]> https://www.soliforum.com/post/129324/#p129324 ostuff wrote:

My davinci junior is digging into the protective tape covering the build plate. Any ideas?

Your Z height is set wrong. Or the bed is unlevel. Have you tried calibration?

]]> Sat, 17 Dec 2016 21:56:08 +0000 https://www.soliforum.com/post/129324/#p129324 <![CDATA[Davinci jr print head digging into protective tape]]> https://www.soliforum.com/post/129322/#p129322 My davinci junior is digging into the protective tape covering the build plate. Any ideas?

]]> Sat, 17 Dec 2016 19:18:06 +0000 https://www.soliforum.com/post/129322/#p129322