<![CDATA[SoliForum - 3D Printing Community — Da vinci jr ramps auto level]]> https://www.soliforum.com/topic/15811/da-vinci-jr-ramps-auto-level/ Wed, 28 Dec 2016 19:24:51 +0000 PunBB <![CDATA[Re: Da vinci jr ramps auto level]]> https://www.soliforum.com/post/129991/#p129991 i tried it and it did a horrible job.. i plan on trying again tonight but every single time i do it it ends up with a bed impact. I think because our end stops are a negative Z value its ignoring my z offset when you do homing so i think i have to artificially set the Z to (Proper Z) + (Offset) on each probe on the mesh. Ill update tonight.

]]> Wed, 28 Dec 2016 19:24:51 +0000 https://www.soliforum.com/post/129991/#p129991 <![CDATA[Re: Da vinci jr ramps auto level]]> https://www.soliforum.com/post/128814/#p128814 @kr15 Yeah typo on my end.. And Yes I'm talking about software auto level using measurements from a probe like the i3 do

]]> Tue, 06 Dec 2016 15:08:58 +0000 https://www.soliforum.com/post/128814/#p128814 <![CDATA[Re: Da vinci jr ramps auto level]]> https://www.soliforum.com/post/128813/#p128813 @kr15 Yeah typo on my end.. And Yes I'm talking about software auto level using measurements from a probe like the i3 do

]]> Tue, 06 Dec 2016 15:08:52 +0000 https://www.soliforum.com/post/128813/#p128813 <![CDATA[Re: Da vinci jr ramps auto level]]> https://www.soliforum.com/post/128809/#p128809 rookesrobotics wrote:

Anyone tried auto level on the jr with ramps installed? I know a issue is the fact it only has one Y stepper Motor.. Any way around it?

I thought auto leveling was achieved by varied Z height controlled by fuzzy math based on premeasered zones around the bed.

At X coordinate Z height is varied depending in premeasered for that coordinate.

]]> Tue, 06 Dec 2016 13:37:12 +0000 https://www.soliforum.com/post/128809/#p128809 <![CDATA[Re: Da vinci jr ramps auto level]]> https://www.soliforum.com/post/128806/#p128806 @rookesrobotics - Are you talking about firmware level compensation or mechanical auto bed levelling system?! Call me thick but what's the role of Y steppers in bed levelling?!

]]> Tue, 06 Dec 2016 12:14:50 +0000 https://www.soliforum.com/post/128806/#p128806 <![CDATA[Da vinci jr ramps auto level]]> https://www.soliforum.com/post/128781/#p128781 Anyone tried auto level on the jr with ramps installed? I know a issue is the fact it only has one Y stepper Motor.. Any way around it?

]]> Mon, 05 Dec 2016 17:47:37 +0000 https://www.soliforum.com/post/128781/#p128781