https://www.soliforum.com/topic/15794/da-vinci-jr-printing-tpu/ Tue, 06 Dec 2016 21:03:09 +0000 PunBB https://www.soliforum.com/post/128820/#p128820 ok thank you  could you recommend any other direct drive extruder assembly?

]]> Tue, 06 Dec 2016 21:03:09 +0000 https://www.soliforum.com/post/128820/#p128820 https://www.soliforum.com/post/128712/#p128712 @destroyer - yes and no. You can do direct drive if you design your own bracket for the hotend and the stepper, but not Titan. Jr uses non geared system with MK7 hobbed gear so your design  should be based on the same design hence you can't ammend your firmware. Using different design you'll end up with overextrusion or underextrusion. Alternatively you could adjust your flow rate in your slicer to compensate that but that can't be done in XYZWare - you need to use Cura or any other slicer.

]]> Sun, 04 Dec 2016 10:27:12 +0000 https://www.soliforum.com/post/128712/#p128712 https://www.soliforum.com/post/128641/#p128641 @kr15_uk ok thats what I was thinking.  Would it be possible to install a direct drive extruder?
http://e3d-online.com/Titan-Extruder

]]> Thu, 01 Dec 2016 22:05:17 +0000 https://www.soliforum.com/post/128641/#p128641 https://www.soliforum.com/post/128633/#p128633 @destroyer - FlexTPU = no chance. Haven't attempted any others but I highly doubt it will. Bowden setup is no good for flexibles to start with, extruder has all gears exposed so filament kinks in there instantly and last thing is the hotend head itself - if you open it up you'll see that there are open gapps in filament path between pushfit connector, filament sensor and then hottend entrance hole.

]]> Thu, 01 Dec 2016 16:55:35 +0000 https://www.soliforum.com/post/128633/#p128633 https://www.soliforum.com/post/128610/#p128610 Would it be possible for the da Vinci jr to print tpu and other flexible materials?

]]> Wed, 30 Nov 2016 21:12:31 +0000 https://www.soliforum.com/post/128610/#p128610