https://www.soliforum.com/topic/15792/updated-firmware-now-only-prints-on-the-left-edge-of-bed/ Thu, 01 Dec 2016 00:34:03 +0000 PunBB https://www.soliforum.com/post/128615/#p128615 And why would you redo firmware to install a lead screw.
Z steps can be changed via RH without reloading firmware.
Did you load the same firmware you were using ?
What printer do you have.
sounds like some settings are different check your x and y max settings

]]> Thu, 01 Dec 2016 00:34:03 +0000 https://www.soliforum.com/post/128615/#p128615 https://www.soliforum.com/post/128581/#p128581 Hi Just upgraded to lead screws for the z axis. Had to re due firmware (marlin) on a ramps 1.4 board and now it only prints on the far edge of the glass? I am not sure why?

]]> Wed, 30 Nov 2016 16:10:07 +0000 https://www.soliforum.com/post/128581/#p128581