<![CDATA[SoliForum - 3D Printing Community — First impressions of PolyFlex and Low Warp ABS filaments]]> https://www.soliforum.com/topic/15724/first-impressions-of-polyflex-and-low-warp-abs-filaments/ Tue, 22 Nov 2016 23:41:07 +0000 PunBB <![CDATA[Re: First impressions of PolyFlex and Low Warp ABS filaments]]> https://www.soliforum.com/post/128276/#p128276 I just used PolyFlex in my Robox printer with no problems. Very nice indeed.

]]> Tue, 22 Nov 2016 23:41:07 +0000 https://www.soliforum.com/post/128276/#p128276 <![CDATA[Re: First impressions of PolyFlex and Low Warp ABS filaments]]> https://www.soliforum.com/post/128182/#p128182 +1

]]> Thu, 17 Nov 2016 16:23:09 +0000 https://www.soliforum.com/post/128182/#p128182 <![CDATA[First impressions of PolyFlex and Low Warp ABS filaments]]> https://www.soliforum.com/post/128157/#p128157 I am finally getting around to using this Low Warp ABS by Push Plastic in my Robox. It’s pretty sweet. I printed two parts known to want to lift and curl at the corners with nary a squiggle. I use the same printing parameters as normal ABS. I also don’t notice any odor although that is not conclusive since I am not bothered by normal ABS odor.

I am still testing it but so far I am quite happy with PolyMaker’s  PolyFlex filament. It loads easily in my direct drive HICTOP i3 Prusa clone, feeds well and prints with good detail and a nice finish. I liken it to something between NinjaFlex and SemiFlex. To me, NinjaFlex is a pain in the behind to feed while SemiFLex feeds well but makes a plasticy, but flexible, part. PolyFlex makes a rubbery part that seems like it could bend and twist many, many times with no problem.
I expect to be using a lot of these filaments from now on.

]]> Wed, 16 Nov 2016 03:42:33 +0000 https://www.soliforum.com/post/128157/#p128157