<![CDATA[SoliForum - 3D Printing Community — Proper mechanical assembly?]]> https://www.soliforum.com/topic/15702/proper-mechanical-assembly/ Sat, 07 Jan 2017 18:24:01 +0000 PunBB <![CDATA[Re: Proper mechanical assembly?]]> https://www.soliforum.com/post/130689/#p130689 9mm is fine. Do check that the auger cannot push on the gearbox though.

]]> Sat, 07 Jan 2017 18:24:01 +0000 https://www.soliforum.com/post/130689/#p130689 <![CDATA[Re: Proper mechanical assembly?]]> https://www.soliforum.com/post/130676/#p130676 Mine is 9mm (instead the 5mm said in manual) is ok or have to add washers?

]]> Sat, 07 Jan 2017 15:57:35 +0000 https://www.soliforum.com/post/130676/#p130676 <![CDATA[Re: Proper mechanical assembly?]]> https://www.soliforum.com/post/128028/#p128028 15mm is a bit long, just install a set of the extra spacers between the motor and chassis, then move the shaft collar 6mm.

]]> Wed, 09 Nov 2016 23:55:28 +0000 https://www.soliforum.com/post/128028/#p128028 <![CDATA[Proper mechanical assembly?]]> https://www.soliforum.com/post/128026/#p128026 Hello!

I wonder if the exceeding of the feed screw remains correct (15 mm),
http://i.imgur.com/7BINtYG.jpg
http://i.imgur.com/qwo5MNs.jpg

same question to the angle of the groove (but it looks okay)!
http://i.imgur.com/qVyEo25.jpg
http://i.imgur.com/2NV9dPI.jpg

The axial movement between the shaft collar and the thrust bearing is a bit high, over 3 mm(18.72-15.55=2.72), it can go?
http://i.imgur.com/pk0t8Z8.jpg
http://i.imgur.com/pRjm8xd.jpg

The tube is not perpendicular to the frame but the screw is loose, so it must go!
http://i.imgur.com/dRSj8Ki.jpg
http://i.imgur.com/aFEOwUc.jpg

Recommendations?
Thanks for answers!

]]> Wed, 09 Nov 2016 22:14:17 +0000 https://www.soliforum.com/post/128026/#p128026