<![CDATA[SoliForum - 3D Printing Community — (S4) PLA fan duct for Lawsy carriage and Lite6?]]> https://www.soliforum.com/topic/15695/s4-pla-fan-duct-for-lawsy-carriage-and-lite6/ Sat, 05 Nov 2016 18:43:50 +0000 PunBB <![CDATA[Re: (S4) PLA fan duct for Lawsy carriage and Lite6?]]> https://www.soliforum.com/post/127965/#p127965 AZERATE wrote:

http://www.thingiverse.com/thing:154544
I use this on two printers...one with a Lite6 and the other a v6, but but have a Volcano block which adds extra length similar to the v5 this was designed for.

Print this up in ABS. If it doesn't clear, it is nothing a Dremel or safe use of a razor can't fix.

Is there one that uses a 40x10 fan? only because I have an extra one I dont use. But if not then ill defiantly use that one you linked

]]> Sat, 05 Nov 2016 18:43:50 +0000 https://www.soliforum.com/post/127965/#p127965 <![CDATA[Re: (S4) PLA fan duct for Lawsy carriage and Lite6?]]> https://www.soliforum.com/post/127954/#p127954 http://www.thingiverse.com/thing:154544
I use this on two printers...one with a Lite6 and the other a v6, but but have a Volcano block which adds extra length similar to the v5 this was designed for.

Print this up in ABS. If it doesn't clear, it is nothing a Dremel or safe use of a razor can't fix.

]]> Sat, 05 Nov 2016 01:45:07 +0000 https://www.soliforum.com/post/127954/#p127954 <![CDATA[(S4) PLA fan duct for Lawsy carriage and Lite6?]]> https://www.soliforum.com/post/127953/#p127953 Greetings,
I posted a while ago about switching to PLA and looking for a fan duct for my S4. it has a E3D Lite6 with Lawsy carriages.
I saw Ticktock has a really good one for the S4 with stock carriages and wondering if there is a carriage that will fit or if I could just cut the bottom of my stock metal bracket and use ticktock's duct ok? like will clearance be ok or if anyone has done this?

Thank you

]]> Sat, 05 Nov 2016 00:15:32 +0000 https://www.soliforum.com/post/127953/#p127953