<![CDATA[SoliForum - 3D Printing Community — Establish local area network]]> https://www.soliforum.com/topic/15687/establish-local-area-network/ Sun, 27 Nov 2016 22:48:13 +0000 PunBB <![CDATA[Re: Establish local area network]]> https://www.soliforum.com/post/128419/#p128419 you should be getting a link-local ip address in the 169.254.*.* range if you're connecting directly...
This ip address will change randomly, so it's  best to set up a static ip that wont collide with your other networks, eg 192.168.15.1 on your pc, and 192.168.15.2 on the pi, with a netmask of 255.255.255.0 and gateway of 192.168.15.1 on both devices.

You shouldn't need a crossover cable unless your computer is pre-2005, all current ethernet ports have auto mdi-x.

]]> Sun, 27 Nov 2016 22:48:13 +0000 https://www.soliforum.com/post/128419/#p128419 <![CDATA[Re: Establish local area network]]> https://www.soliforum.com/post/127952/#p127952 I've tried a crossover cable and still no IP address. I've read something at needing to configure a static IP, but didn't find any details.

]]> Fri, 04 Nov 2016 23:51:56 +0000 https://www.soliforum.com/post/127952/#p127952 <![CDATA[Re: Establish local area network]]> https://www.soliforum.com/post/127935/#p127935 Try  either a crossover cable or an Internet switch  box.

]]> Fri, 04 Nov 2016 10:35:46 +0000 https://www.soliforum.com/post/127935/#p127935 <![CDATA[Establish local area network]]> https://www.soliforum.com/post/127923/#p127923 Is it possible to connect the atlas 3d direct to a computer with a ethernet cable? I've been unable to get an IP address. Wireless still works but I'm going somewhere where I won't have access to a router or wireless connection.

]]> Fri, 04 Nov 2016 01:01:07 +0000 https://www.soliforum.com/post/127923/#p127923