<![CDATA[SoliForum - 3D Printing Community — PiBot Electronics]]> https://www.soliforum.com/topic/15666/pibot-electronics/ Sat, 29 Oct 2016 12:09:02 +0000 PunBB <![CDATA[Re: PiBot Electronics]]> https://www.soliforum.com/post/127804/#p127804 I have seen them but no experience . Looks like this setup was designed for the cnc market  as well as 3d printing . Looks like that set up or sister product would run a router or small mill with no problem.
Kind of a mid ground rice wise between a ramps and a gecko  drive I like the fact motor power is directly connected to the driver board no where near the controls circuits. Control card as 10x that of the polo drivers but a lot more to the board a huge heat sink  and lots of reserve power If i read correctly the boards will handle 4 amps. (that may be a cnc version) 
You may want to check some of the cnc  hobby forums for reviews.
Seems like a good effort in documentation at least

.Company Information

Room401-5, ChuangXin Building,
ChaoYang Road,
QiXing District, GuiLin, GuangXi, 541001, China

]]> Sat, 29 Oct 2016 12:09:02 +0000 https://www.soliforum.com/post/127804/#p127804 <![CDATA[PiBot Electronics]]> https://www.soliforum.com/post/127801/#p127801 Just curious if anyone has tried these or have any input?

http://www.pibot.com/set-of-pibot-elect … 2-0-d.html

]]> Sat, 29 Oct 2016 01:55:26 +0000 https://www.soliforum.com/post/127801/#p127801