<![CDATA[SoliForum - 3D Printing Community — Settings to make support material easier to remove?]]> https://www.soliforum.com/topic/15338/settings-to-make-support-material-easier-to-remove/ Sat, 13 Aug 2016 20:10:11 +0000 PunBB <![CDATA[Re: Settings to make support material easier to remove?]]> https://www.soliforum.com/post/126202/#p126202 wardjr wrote:

Try going to the extrusion width settings screen and decrease the support extrusion width to a value close to half your nozzle diameter.

My support extrusion width is set at .25 with a .4 nozzel. But ill set it to .2 and see what happens

]]> Sat, 13 Aug 2016 20:10:11 +0000 https://www.soliforum.com/post/126202/#p126202 <![CDATA[Re: Settings to make support material easier to remove?]]> https://www.soliforum.com/post/126069/#p126069 this one:

http://soliforum.com/i/?o8QWDoK.jpg

]]> Thu, 11 Aug 2016 01:44:25 +0000 https://www.soliforum.com/post/126069/#p126069 <![CDATA[Re: Settings to make support material easier to remove?]]> https://www.soliforum.com/post/126059/#p126059 Try going to the extrusion width settings screen and decrease the support extrusion width to a value close to half your nozzle diameter.

]]> Wed, 10 Aug 2016 13:41:04 +0000 https://www.soliforum.com/post/126059/#p126059 <![CDATA[Settings to make support material easier to remove?]]> https://www.soliforum.com/post/126048/#p126048 Greetings,
Sometimes my support material comes off easily and cleanly, but 8 out of 10 times its so hard to remove that I end up sanding it off with a dremel... I was wondering if this is normal and everyone has hard time removing support material or just my possible settings needs tweaking?

http://i.imgur.com/GtPGtnX.png

]]> Wed, 10 Aug 2016 05:30:27 +0000 https://www.soliforum.com/post/126048/#p126048