<![CDATA[SoliForum - 3D Printing Community — Groaning, jaring on the moving y-axis]]> https://www.soliforum.com/topic/1519/groaning-jaring-on-the-moving-yaxis/ Thu, 28 Feb 2013 22:18:50 +0000 PunBB <![CDATA[Re: Groaning, jaring on the moving y-axis]]> https://www.soliforum.com/post/14516/#p14516 Double check that all the set screws on the pulleys are tight.

]]> Thu, 28 Feb 2013 22:18:50 +0000 https://www.soliforum.com/post/14516/#p14516 <![CDATA[Re: Groaning, jaring on the moving y-axis]]> https://www.soliforum.com/post/14514/#p14514 your y axis might have slipped one of the pulleys on the back shaft causing the x,y to bind which could lead to noise and even losing steps, tyr to check if the x,y rods are square if not just loosen one of the pulleys setscrews and adjust it then retighten.

]]> Thu, 28 Feb 2013 22:08:00 +0000 https://www.soliforum.com/post/14514/#p14514 <![CDATA[Re: Groaning, jaring on the moving y-axis]]> https://www.soliforum.com/post/14512/#p14512 satman49 wrote:

Is the bed level?

Yes. Leveled the bed. You think there is a pressure from the printhead onto the bed?

]]> Thu, 28 Feb 2013 21:52:53 +0000 https://www.soliforum.com/post/14512/#p14512 <![CDATA[Re: Groaning, jaring on the moving y-axis]]> https://www.soliforum.com/post/14510/#p14510 Is the bed level?

]]> Thu, 28 Feb 2013 21:46:09 +0000 https://www.soliforum.com/post/14510/#p14510 <![CDATA[Groaning, jaring on the moving y-axis]]> https://www.soliforum.com/post/14505/#p14505 While printig I hear something like a groan or jar from the left backside of my printer.
Happens while printing and moving the y-axis.
While manual control I can't hear anything.

]]> Thu, 28 Feb 2013 21:36:10 +0000 https://www.soliforum.com/post/14505/#p14505