<![CDATA[SoliForum - 3D Printing Community — Barrel rotated under torque, no idea how to correct it!]]> https://www.soliforum.com/topic/15161/barrel-rotated-under-torque-no-idea-how-to-correct-it/ Sat, 23 Jul 2016 22:14:46 +0000 PunBB <![CDATA[Re: Barrel rotated under torque, no idea how to correct it!]]> https://www.soliforum.com/post/125435/#p125435 I've had mine rotate about that much.  I considered it too much of a pain to try to correct when it did not seem to affect my output.

]]> Sat, 23 Jul 2016 22:14:46 +0000 https://www.soliforum.com/post/125435/#p125435 <![CDATA[Re: Barrel rotated under torque, no idea how to correct it!]]> https://www.soliforum.com/post/125368/#p125368 My brutish approach when that happened was to wire the motor in reverse and very slowly turn it back where it should be.

]]> Fri, 22 Jul 2016 18:22:16 +0000 https://www.soliforum.com/post/125368/#p125368 <![CDATA[Re: Barrel rotated under torque, no idea how to correct it!]]> https://www.soliforum.com/post/125105/#p125105 45 degrees is no problem, pellets will still feed.

]]> Fri, 15 Jul 2016 13:15:39 +0000 https://www.soliforum.com/post/125105/#p125105 <![CDATA[Barrel rotated under torque, no idea how to correct it!]]> https://www.soliforum.com/post/125100/#p125100 Hi there folks,

as per the title, the motor rotated the barrel by about 45 degrees, so now the feed hole is offset.

I've given it all the wrench I can muster, but cannot get it to rotate, any ideas?

[img]IMG_20160715_1204476.jpg[/img]

Thanks guys!

]]> Fri, 15 Jul 2016 11:10:56 +0000 https://www.soliforum.com/post/125100/#p125100