<![CDATA[SoliForum - 3D Printing Community — is the new davinci 1.0A firmware safe]]> https://www.soliforum.com/topic/14887/is-the-new-davinci-10a-firmware-safe/ Wed, 01 Jun 2016 13:49:49 +0000 PunBB <![CDATA[Re: is the new davinci 1.0A firmware safe]]> https://www.soliforum.com/post/123634/#p123634 It depends on how you are resetting.  I was using an older Arduino sketch, and the firmware could detect that it was reset, and made the prints look like crap.

A newer sketch I found worked slightly better, but flashing Repetier was ultimately my solution.

]]> Wed, 01 Jun 2016 13:49:49 +0000 https://www.soliforum.com/post/123634/#p123634 <![CDATA[is the new davinci 1.0A firmware safe]]> https://www.soliforum.com/post/123609/#p123609 I reset my cartridges. Would any of the new firmware pose a problem to this?

]]> Tue, 31 May 2016 21:32:27 +0000 https://www.soliforum.com/post/123609/#p123609