<![CDATA[SoliForum - 3D Printing Community — Zebra plate adjust Z height]]> https://www.soliforum.com/topic/14810/zebra-plate-adjust-z-height/ Tue, 17 May 2016 05:27:58 +0000 PunBB <![CDATA[Re: Zebra plate adjust Z height]]> https://www.soliforum.com/post/122979/#p122979 viperz28 wrote:

I wanted to try the Zebra plate but I need to change Z height by 5mm, what is the best method for doing this? I don't want to put into GCode, in case I forget and then ram the hot end into the Zebra plate. EEPROM setting perhaps?

Found the answer here

https://github.com/luc-github/Repetier- … /issues/79

]]> Tue, 17 May 2016 05:27:58 +0000 https://www.soliforum.com/post/122979/#p122979 <![CDATA[Zebra plate adjust Z height]]> https://www.soliforum.com/post/122954/#p122954 I wanted to try the Zebra plate but I need to change Z height by 5mm, what is the best method for doing this? I don't want to put into GCode, in case I forget and then ram the hot end into the Zebra plate. EEPROM setting perhaps?

]]> Tue, 17 May 2016 03:06:52 +0000 https://www.soliforum.com/post/122954/#p122954