<![CDATA[SoliForum - 3D Printing Community — da vinci 1.0a with repetior]]> https://www.soliforum.com/topic/14785/da-vinci-10a-with-repetior/ Thu, 12 May 2016 00:42:32 +0000 PunBB <![CDATA[Re: da vinci 1.0a with repetior]]> https://www.soliforum.com/post/122713/#p122713 Then watch during the print and when you see it stop, note the temp displayed. You could have a faulty connector on the heater like so many 1.0 machines had.

]]> Thu, 12 May 2016 00:42:32 +0000 https://www.soliforum.com/post/122713/#p122713 <![CDATA[Re: da vinci 1.0a with repetior]]> https://www.soliforum.com/post/122710/#p122710 i am using abs with 225c settings

]]> Thu, 12 May 2016 00:31:54 +0000 https://www.soliforum.com/post/122710/#p122710 <![CDATA[Re: da vinci 1.0a with repetior]]> https://www.soliforum.com/post/122709/#p122709 I drilled a small hole in the center of my top and feed from an overhead shelf. As for the stopping check the temp, could be too low and the 1.0 cannot use PLA without mods. So if using PLA, could also be your issue.

]]> Thu, 12 May 2016 00:26:29 +0000 https://www.soliforum.com/post/122709/#p122709 <![CDATA[da vinci 1.0a with repetior]]> https://www.soliforum.com/post/122708/#p122708 my extruder stops pushing filament at different points during prints
i can push the reload and it seems to push filament again but it stops when it continues print

any ideas what i can check?
with using other brand filament where do you guys feed it thru to feed the extruder?

Thanks for your help

Dan

]]> Thu, 12 May 2016 00:16:38 +0000 https://www.soliforum.com/post/122708/#p122708