https://www.soliforum.com/topic/14552/struggling-with-getting-solidoodle-2-back-online/ Mon, 11 Apr 2016 18:01:42 +0000 PunBB https://www.soliforum.com/post/120917/#p120917 PM sent.

]]> Mon, 11 Apr 2016 18:01:42 +0000 https://www.soliforum.com/post/120917/#p120917 https://www.soliforum.com/post/120909/#p120909 Maybe an easier question is does anyone know of a good cheap board I can buy with chip that will be as close as possible to a direct replacement?
Thanks again,
Zach

]]> Mon, 11 Apr 2016 16:23:22 +0000 https://www.soliforum.com/post/120909/#p120909 https://www.soliforum.com/post/120897/#p120897 Hi,
My solidoodle twos been down for a year.  It needed a new extruder assembly so i decided it was time to add an e3d.  It went fine but i went to adjust the firmware to the right emergency temp and i couldn't upload.  It worked on another printer and was tried on multiple computers and ports.  So I bought a programmer.  That didn't work at all either.  So I bought a new solidoodle motherboard minus the chip and that didn't work.  So then I bought one of these with the optiboot boot loader and i could never figure out how to get that going either.  I finally got close to just adding a new board but it looks like theres a lot of rewiring involved that i just don't want to go through.  Can anyone shed some light on this problem?
New chip
http://www.ebay.com/itm/ATmega644P-PU-w … xy-j9SON0m

]]> Mon, 11 Apr 2016 04:51:59 +0000 https://www.soliforum.com/post/120897/#p120897