<![CDATA[SoliForum - 3D Printing Community — How to make your own Support structures]]> https://www.soliforum.com/topic/14497/how-to-make-your-own-support-structures/ Wed, 06 Apr 2016 03:22:38 +0000 PunBB <![CDATA[Re: How to make your own Support structures]]> https://www.soliforum.com/post/120590/#p120590 Thanks, I'll take a look. I've made supports in the past but had probs getting them to release cleanly. Cura doesn't always put them where/how I want them to go.

]]> Wed, 06 Apr 2016 03:22:38 +0000 https://www.soliforum.com/post/120590/#p120590 <![CDATA[Re: How to make your own Support structures]]> https://www.soliforum.com/post/120575/#p120575 experimentation?

Meshmixer will allow you to create supports that you can control placement of as well as size etc...

]]> Wed, 06 Apr 2016 00:03:45 +0000 https://www.soliforum.com/post/120575/#p120575 <![CDATA[How to make your own Support structures]]> https://www.soliforum.com/post/120572/#p120572 Where do I find the specifics on this. How thin, layer heights, etc?

]]> Tue, 05 Apr 2016 23:53:46 +0000 https://www.soliforum.com/post/120572/#p120572