SoliForum - 3D Printing Community — How send m code in mac n rh

Re: How send m code in mac n rh

null@example.com (nickythegreek) — Sun, 24 Feb 2013 17:57:01 +0000

Can you post a picture of your RH screen on the Print Panel after you manually send the command.

null@example.com (jjcuff1) — Sun, 24 Feb 2013 17:54:50 +0000

Thanks

But how do you run the command to the printer?

I tried rh and send comman box and nothing happens
Nothing in log? Do i need to use ardunio or probterface

I have a mac and the printer connets and works no problems

null@example.com (jon_bondy) — Sun, 24 Feb 2013 15:01:41 +0000

nickythegreek wrote:

I wrote up a wiki page on what to expect during this procedure here:
http://www.soliwiki.com/PID_tuning

This is really wonderful! Thanks Nicky!

null@example.com (nickythegreek) — Sun, 24 Feb 2013 04:31:40 +0000

Can you post a screenshot of your RH a couple seconds after you send this command:

M303 S200 C5

I wrote up a wiki page on what to expect during this procedure here:
http://www.soliwiki.com/PID_tuning

null@example.com (jjcuff1) — Sun, 24 Feb 2013 04:25:15 +0000

Ok i have sd 2 mac rh and slicr and it works fine
But trying to run m303 codes in rh via print n send and nothing

I jave tried using gcode manually n by editing and running print
Job even but m303 no send

I am connected and can print and move head etc

But does rh not work with mac? I have uldated marlin too no pronlem
With firmware updates