<![CDATA[SoliForum - 3D Printing Community — Aluminum Chassi Problem]]> https://www.soliforum.com/topic/14250/aluminum-chassi-problem/ Sat, 12 Mar 2016 12:55:48 +0000 PunBB <![CDATA[Re: Aluminum Chassi Problem]]> https://www.soliforum.com/post/119131/#p119131 I had the same problem with mine so I removed about 3mm of material in the mounting holes and pass-thru hole opposite the motor assembly towards the top of the unit to get better alignment - fixed the issue without any additional interferences.  Note: One of the flange mount bolt heads needs to be shaved down some on one or the flats to allow the side panel screw to pass between the aluminum side and the bolt head to fit properly. smile

]]> Sat, 12 Mar 2016 12:55:48 +0000 https://www.soliforum.com/post/119131/#p119131 <![CDATA[Re: Aluminum Chassi Problem]]> https://www.soliforum.com/post/118928/#p118928 Ok, i will go ahead and finish the assembly and see how it goes.

BEst Regards

Andrade

]]> Tue, 08 Mar 2016 18:04:40 +0000 https://www.soliforum.com/post/118928/#p118928 <![CDATA[Re: Aluminum Chassi Problem]]> https://www.soliforum.com/post/118927/#p118927 The raw material is not a perfect square, this is OK because the hex socket allows for a few degrees of misalignment. I do not anticipate you'll have any problems, but we can set up an exchange or replacement if you'd like - use the contact form on the Filastruder site.

]]> Tue, 08 Mar 2016 17:35:39 +0000 https://www.soliforum.com/post/118927/#p118927 <![CDATA[Aluminum Chassi Problem]]> https://www.soliforum.com/post/118926/#p118926 Hello, i bought a Filastruder V2 but the Aluminum Chassi does not appear to be  a perfect square.
Please see the pictures below.
http://soliforum.com/i/?TUDNxhn.jpg

http://soliforum.com/i/?92Ud6xd.jpg

I need to get a replacement for this part because the auger bit is not going straight into the motor socket.

Please let me know how to proceed.

Best Regards

Andrade

]]> Tue, 08 Mar 2016 17:17:18 +0000 https://www.soliforum.com/post/118926/#p118926